Description
IMPORTANT: The following item should be ordered separately: Clamshell Clamp Weld Ferrule, two required per clamp.
Our clamp is designed to accommodate multiple sized aluminum tubing found on most blower or turbo applications and will withstand 60 pounds of boost! The clamp can be removed and/or re-installed with the quick release pin. This is accomplished without tools, just your fingers. There are no hoses to “stretch” over the tubing or throttle body or metal hose clamps to unscrew or re-tighten. The use of our clamp can eliminate wasted time between rounds at the track.
Quick Disconnect Clamps are available color anodized in black or blue, sizes range from 2″ to 5″. Not all sizes available in both colors. To determine which size clamp and aluminum weld ferrule to purchase depends on the diameter of your tube. If the diameter of your tube is 4″ at the welding point, then order a 4″ clamp and two 4″ weld ferrules, sold separately. Weld the ferrules on to each side of the tube where a connection is required. Install a lubricated o-ring into the ferrule o-ring groove, slip the inner sleeve over one ferrule and pull sleeve over the other ferrule. Install clamp over the sleeve and engage the quick disconnect locking pin. Check your o-rings for general wear and tear as they are a maintenance item and should be replaced when needed.
This clamp can be used with our MAX version throttle body product line.
Includes: One inner sleeve and one quick disconnect pin. (Weld Ferrules sold separately)
Disclaimer
Our products have been designed for off road/racing applications only. These products are not legal for use in the state of California on any pollution/control motor vehicle. These performance products are legal in California only on a racing vehicle which may never be used or driven on a public highway.
CA WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov
John Gardner –
Replace the cotter pin with a quick release pin. The pin that currently comes with this scratches the anodized finish. The push button quick release pin would look better too.
Dale Minton (verified owner) –
be nice if it had a quick release pin instead of the hairpins
Jen (store manager) –
Thank you for your input. The Cotter Pin provided is considered quick release, but it does fit quite snugly.
william a w. (verified owner) –